Pioneer DVR-310-S Operating Instructions Manual page 28

Getting started
04
Playing DVD discs
The table below shows the basic playback controls for
DVD-Video, and recordable DVD discs.
Press to start playback.
PLAY
If RESUME is displayed on-screen, play-
back starts from the place last stopped.
Press to stop playback.
STOP
You can resume playback from the same
point by pressing
again to cancel the resume function.)
Pauses playback, or restarts playback
PAUSE
when paused.
Press to start scanning. Press repeatedly
REV SCAN FWD SCAN
to increase the scanning speed. (There are
four scan speeds; the current scan speed
is shown on-screen.)
Press to skip to previous/next chapter/title.
PREV NEXT
Except VR mode: During playback, enter a
chapter number then press ENTER to skip
directly to that chapter within the currently
playing title.
CLEAR
On some discs, you can also use the num-
ber buttons to select numbered items in
the disc menu.
VR mode only: During playback, enter a
title number then press ENTER.
(Commercial skip) Each press skips for-
CM SKIP
ward 30 seconds. Use to a maximum of 4
mins.
During playback, press to start slow-
STEP/SLOW
motion playback. Press repeatedly to
change the playback speed.
While paused, press to advance a single
frame in either direction.
Press to display the 'top' menu or menu of
a DVD-Video disc (these are often the
TOP MENU MENU
same).
Use the cursor buttons to navigate DVD-
Video disc menus; press ENTER to select
ENTER items.
Press to return to the previous level of a
RETURN
DVD-Video disc menu.
28
En
Playing CDs and WMA/MP3 discs
The table below shows the basic playback controls for
audio CDs, and WMA/MP3 files.
PLAY. (Press STOP
Press to start playback.
PLAY
Press to stop playback.
STOP
Pauses playback, or restarts playback
PAUSE
when paused.
CD and MP3 only: Press to start scanning.
REV SCAN FWD SCAN
Press again to increase the scanning
speed. (There are two scan speeds; the
current scan speed is shown on-screen.)
Press to skip to previous/next track (or
PREV NEXT
folder for WMA/MP3 disc).
During playback, enter a track number
then press ENTER to skip directly to that
track.
CLEAR
Note
• If you want to play a DTS audio CD, make sure the
recorder is connected to a DTS-compatible amplifier
with a digital connection. Noise will be output
through the analog outputs. Also make sure that
STEREO is selected using the AUDIO button (see
Changing audio channels on page 27).
• Scanning doesn't work with WMA tracks.