Bosch WGG244M40 Instructions For Use And Assembly page 42

de Troubleshooting
disturbance
Detergent does not work
pumped out.
Water does not run in.
Detergent won't
washed in.
Repeated arrival
fling.
Program duration change
changes during the
washing process.
42
Cause and troubleshooting
Immediate measure: Mix a tablespoon of fabric
▶
softener with 0.5 liters of water and pour the
mixture into the left compartment (not for outdoor,
sportswear and down textiles).
For the next wash cycle with the same load, reduce
▶
the amount of detergent.
Inadmissible extension mounted on the water
drainage hose.
Remove impermissible extensions from the water
▶
drainage hose. Connect device
Start / reload was not pressed.
Press Start / reload.
▶
The filter in the water inlet is blocked.
Clean the sieve in the water inlet.
▶
The tap is closed.
Open the faucet.
▶
The water inlet hose is kinked or trapped.
Make sure that the water inlet hose is not kinked or
▶
pinched.
The unbalance control system compensates for the unbalance
by distributing the laundry several times.
No mistake - no action required.
▶
Notice: When loading, place large and small items of
laundry together in the drum. Laundry items of
different sizes are better distributed during spinning.
The program sequence is electronically optimized. This can
lead to a change in the program duration.
No mistake - no action required.
▶
The unbalance control system compensates for the unbalance
by distributing the laundry several times.
No mistake - no action required.
▶
Notice: When loading, place large and small items of
laundry together in the drum. Laundry items of
different sizes are better distributed during spinning.
The foam control system switches on a rinse cycle if the
foam builds up too much.
No mistake - no action required.
▶