disturbance
"E: 36 / -10"
"E: 36 / -25 / -26"
"E: 38 / -25 / -26"
"E: 35 / -10"
shines.
Cause and troubleshooting
Remove impermissible extensions from the water
▶
drainage hose. Connect device
Pump cover is not screwed in completely.
Make sure that the pump cover is screwed into the
▶
device as far as it will go. The handle of the pump
cover must be vertical.
The drain pump is blocked.
→
"Cleaning the drain pump ", page 35
▶
The drain pump is blocked.
→
"Cleaning the drum ", page 34
▶
if the error is displayed again,
→
"Cleaning the drain pump ", page 35
▶
The inlet opening of the rubber boot is blocked.
→ "Clean the inlet opening in the rubber sleeve ",
▶
page 37
Water pressure is low. No
fix possible.
The filter in the water inlet is blocked.
Clean the sieve in the water inlet.
▶
The tap is closed.
Open the faucet.
▶
The water inlet hose is kinked or trapped.
Make sure that the water inlet hose is not kinked or
▶
pinched.
There is water in the bottom pan.
Turn off the faucet.
▶
Call customer service.
▶
→
"Customer Service ", page 48
Device is leaking.
Turn off the faucet.
▶
Call customer service.
▶
→
"Customer Service ", page 48
Temperature is too high.
Wait until the temperature has dropped.
▶
→ "Abort program ", page 32
▶
The water level is too high.
Start the program Pumping out.
▶
Laundry is jammed in the door.
Open the door again.
1.
Troubleshooting de
39