Din Rear-Mount; Switching The Dsp Setting Mode; About The Fixing Screws For The Front Panel - Pioneer DEH-P860MP Premier Installation Manual

Installation
Installation without the rubber bush (Fig. 7)
Dashboard
Nut (5 mm)
Drill a 5.5 – 6.0 mm
diameter hole.
Strap
Be sure to use the strap to secure the back
Screw (5 × 16 mm) of the unit in place. The strap can be bent
by hand to the desired angle.
Screw
Nut (5 mm)
Removing the Unit (Fig. 8) (Fig. 9)
Frame
Insert the release pin into the hole in
the bottom of the frame and pull out
to remove the frame.
(When reattaching the frame, point
the side with a groove downwards
and attach it.)
Insert the supplied extraction keys into the unit, as
shown in the figure, until they click into place. Keeping
the keys pressed against the sides of the unit, pull the
unit out.

DIN Rear-mount

Installation using the screw holes on the side of the unit
1. Remove the frame. (Fig. 10)
Frame
Insert the release pin into the hole in
the bottom of the frame and pull out
to remove the frame.
(When reattaching the frame, point
the side with a groove downwards
and attach it.)
Fig. 7
2. Fastening the unit to the factory radio mounting bracket.
(Fig. 11) (Fig. 12)
Select a position where the screw holes of the bracket and
the screw holes of the head unit become aligned (are fitted),
and tighten the screws at 2 places on each side. Use either
binding screws (5 × 8 mm) or flush surface screws
(5 × 9 mm), depending on the shape of the screw holes in
the bracket .
Fig. 8
Fig. 9
Factory radio mounting bracket

Switching the DSP setting mode

This product features two operation modes: the 3-way network mode (NW) and the standard
mode (STD). You can switch between modes as desired. Initially, the DSP setting is set to
the standard mode (STD).
• After switching, reset the microprocessor. (Refer to operation manual.)
• Use a thin standard tip screwdriver to switch the DSP switch on the side of this
product.
Fig. 10

About the fixing screws for the front panel

If you do not operate the removing and attaching the front panel function, use the supplied
fixing screw to fix the front panel to this unit.
Fig. 11
Screw
Dashboard or Console
Fig.12
<ENGLISH>
Fig. 13
Fixing screw
Fig. 14