Prior To Taking The Machine Into Service; Taking The Machine Into Service; Rating Data - Bevel Tools Mate EBA-12 Instruction Manual

2.1 Prior to taking the machine into service

i
Before connecting the tool to a power source, be sure the voltage supplied is the same as specified on the name plate
of the tool. The power supply should not vary more than 10% above or below the voltage indicated on the name plate.
Working with worn or damaged bevel heads will cause the machine to fail.
• Check bevel head prior to use.
• A sharp bevel head will increase cutting speed and machine life.
• The bevel head must be changed regularly.
• The bevel head must be mounted centrally and positioned against the limit stop.
• The maximum allowable speed of the tool and of the chuck may not be exceeded under any circumstances.
• Observe national regulations.

2.2 Taking the machine into service

Preselect speed with adjusting wheel according to speed table.
Adjusting wheel increment
1
2
3
4
5
6
During operation, never increase the speed of the machine to above that of the maximum admissible speed of the
grinding tool!
2.2.1 Turn on
!
• Always wear protective clothing, safety shoes, safety glasses and ear protection.
• Make sure you always have a firm footing when working with the machine.
• Whatever the position of the machine, always use two hands to control the machine.
• Never touch the bevel head when the machine is running.
• Never use the machine above head height.
• The machine should only be used for conventional up-cut milling.
• To turn the machine on, press the ON/OFF handle and hold.
• Bring the machine slowly into contact with the work piece only after the selected tool speed has been reached.
• When cutting a bevel, always move the machine from left to right against the rotation direction of the bevel head.
• When machining bore holes, always work in a clockwise direction.
2.2.2 Turn off
• Take beveling machine from work piece and turn off.
• Motor stops.

2.3 Rating data

Power voltage (cf. replacement parts list)
Power Input
Power Output
No-load speed
Max. wheel diameter
Grinding spindle thread
Sound pressure level according to EN 60745
Noise emission level
Vibration according to EN 60745
Weight w/o cord set
Protection class
EN
Min / rpm
-1
4.200
5.200
6.400
7.600
8.800
10.000
3
120/230V; 50/60 Hz; 120/230V
1530 W
1000 W
10500 min /rpm
-1
45 mm
M8
89 dB (A) K = 3 dB
100 dB (A) K = 3 dB
<2.5 m/s2 K = 1.5m/s2
4.3 kg
/ II