Assembling The Light Kit - Hunter Marconi Installation Manual

Partially install switch housing
screws, found in the
bag, halfway into the motor housing
as shown. It does not matter which
two screw holes you choose.
Connect the plugs from the upper and lower
switch housings. Make sure to line up the colored
markings on the connectors. Lift the lower switch
housing until its screw holes are aligned with the
screw holes in the upper switch housing.
the two light kit screws, found in the
Tighten both screws.
Install the included bulbs into the
sockets. When necessary, replace
with bulbs of same wattage.
Note:
Fan style may vary.
Ceiling Bracket Downrod

Assembling the LIght Kit

2 of 3
Switch
Housing
Screw
bag
hardware
bag
Install
hardware bag.
Installing the Bulbs and Glass
Rest the globe in the globe retainer.
Hanging Fan Wiring
Feed the wire plug through the center
hole of the upper switch housing,
then wrap keyhole slots around the
screws and twist counterclockwise.
2 of 2
Light Kit Screw
Note:
Fan style may vary.
Lift the globe assembly and align
the screw holes of the globe retainer
with the screw holes with upper
switch housing.
Canopy Blades
bag
Insert the third screw, found in the
hardware bag, into place and then tighten
all three screws.
WARNING
FAN FALL HAZARD
Make sure all screws are tight to secure
the light fixture.
bag
Install the three globe retainer screws, found
in the hardware bag. Tighten all three
screws.
WARNING
GLASS FALL HAZARD
To prevent SERIOUS INJURY or DEATH, make
sure that glass is properly secured.
Light Glass/Bulbs
1886
1 of 3
Switch
Housing
Screw
x3
Globe
Retainer
Screws
8
Remote