Mitsubishi Electric PSA-RP71KA Service Manual page 29

OPERATING PROCEDURE
8. Removing the indoor heat exchanger
(1) Remove the intake grille. (Refer to Procedure 1)
(2) Remove the front panel. (Refer to Procedure 5)
(3) Remove the swing louver. (See Photos 6-1 and 6-2)
(4) Remove the 6 screws of the top panel and
remove the top panel. (See Photo 6-1)
(5) Remove the insulation panel. (See Photo 7-1)
(6) Remove the electrical parts cover and electrical
parts box. (Refer to Procedure 2)
(7) Remove the 2 screws of the drain pan support
and remove the drain pan support. (See Photos
8-2 and 9)
(8) Remove the screw of pipe support and remove
the pipe support.
(9) Remove the 4 screws of the indoor heat
exchanger.
(10) Remove the indoor heat exchanger.
Photo 8-2
Screws of electrical parts box
9. Removing the drain pan
(1) Remove the intake grille. (Refer to Procedure 1)
(2) Remove the front panel. (Refer to Procedure 5)
(3) Remove the swing louver. (See Photo 6-1 and 6-2)
(4) Remove the top panel. (See Photos 6-1)
(5) Remove the insulation panel. (See Photo 7-1)
(6) Remove the electrical parts cover, electrical parts
box and the drain pan support. (See Photo 8-1)
(7) Remove the pipe support. (See Photo 8-2)
(8) Remove the indoor heat exchanger. (See Photo 8-1)
(9) Remove the drain pan.
OCH528B
Photo 8-1
Indoor heat
exchanger
Drain pan
Pipe support
Screw of
pipe support
Photo 9
Screws of drain pan support
29
PHOTOS/FIGURES
Screws of indoor heat exchanger
Screws of drain pan support
Drain pan
Indoor heat
exchanger
Drain pan
support
Drain pan
support