Table of Contents
Advertisement
06/03/06 13:50:09 3CMCJ600_105
Installation:
1.
Position the wheel between the fork legs
and insert the front axle shaft from the
left side, through the left fork leg and
wheel hub.
2.
Align the end of axle (1) with the surface
of fork leg (2).
3.
Tighten the axle pinch bolt on the left
fork leg to the specified torque:
22 N·m (2.2 kgf·m , 16 lbf·ft)
4.
Tighten the axle bolt to the specified
torque:
78 N·m (8.0 kgf·m , 58 lbf·ft)
5.
Install the right and left caliper assembly
to the fork legs and tighten the fixing
bolts to the specified torque:
30 N·m (3.1 kgf·m , 22 lbf·ft)
To avoid damaging the brake pads while
installing the caliper assembly, carefully
fit both brake disks between the pads.
6.
Operate the front brake and pump the
fork several times. Check for free wheel
rotation after the brake is released.
Recheck the wheel if the brake drags or
the wheel does not rotate freely.
7.
Tighten the axle pinch bolts on the right
fork leg to specified torque:
22 N·m (2.2 kgf·m , 16 lbf·ft)
If a torque wrench was not used for
installation, see your Honda dealer as
soon as possible to verify proper as-
sembly. Improper assembly may lead
to loss of braking capacity.
(1) End of axle
(2) Surface of fork leg
(2)
(1)
99
Advertisement
Table of Contents
