Example Of Installation On The Floor Mat Or On The Chassis; Replacing The Terminal Cover; Changing The Direction Of The Badge - Pioneer Premier PRS-D2000SPL Owner's Manual

Example of installation on the floor
mat or on the chassis
1. Place the amplifier where it is to be
installed. Insert the supplied tap-
ping screws (4 mm × 18 mm) into
the screw holes. Push on the screws
with a screwdriver so they make
marks where the installation holes
are to be located.
2. Drill 2.5 mm (1/8 in.) diameter holes
at the point marked, and install the
amplifier, either on the carpet or
directly to the chassis.
Tapping screw
(4 mm × 18 mm)
Floor mat or chassis
Drill a 2.5 mm (1/8 in.)
diameter hole

Replacing the terminal cover

1. Align the unit and terminal cover,
and insert the screw.
2. Tighten the screw with a 4 mm
hexagonal wrench.
Screw

Changing the Direction of the Badge

1. To remove the badge, loose screws
by using a 2 mm hexagonal wrench.
2. Change the direction of badge, and
then tighten the screws with a
hexagonal wrench.
Screw
Terminal Cover
Badge
16