Makita DPB183 Instruction Manual page 8

Cordless portable band saw
Hide thumbs Also See for DPB183:
Table of Contents

Advertisement

NOTICE:
When changing the speed dial from "6"
to "1", turn the dial counterclockwise. Do not turn
the dial clockwise forcibly.
NOTICE:
Plastic materials may melt when cut-
ting at high speeds.
Lighting up the front lamp
CAUTION:
Do not look in the light or see the
source of light directly.
Pull the switch trigger to light up the lamp. The lamp
keeps on lighting while the switch trigger is being pulled.
The lamp goes out approximately 10 seconds after
releasing the switch trigger.
1
► 1 . Lamp
NOTE: Do not apply impact to the lamp, which may
cause damage or shorted service time to it.
NOTE: Use a dry cloth to wipe the dirt off the lens of
the lamp. Be careful not to scratch the lens of lamp, or
it may lower the illumination.
NOTE: When the tool is overheated, the lamp blinks
for one minute, and then goes off. In this case, cool
down the tool before operating again.
ASSEMBLY
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before carrying out any work on the tool.
Installing or removing the band saw blade
CAUTION:
Oil on the band saw blade can
cause the blade to slip or come off unexpectedly.
Wipe off all excess oil with a cloth before install-
ing the band saw blade.
CAUTION:
Always wear protective gloves
when handling the band saw blade.
CAUTION:
Use caution when handling the
band saw blade to avoid cut by the sharp edge of
the blade teeth.
CAUTION:
Keep your body away from
the band saw blade when checking the blade
movement.
CAUTION:
When turning the blade tightening
lever clockwise to release the tension on the band
saw blade, point the tool downward because the
band saw blade may come off unexpectedly.
To install the band saw blade:
1.
Turn the blade tightening lever clockwise until it
stops to loosen the wheel.
3
► 1 . Tighten 2. Loosen 3. Blade tightening lever
2.
Open the wheel cover.
1
► 1 . Wheel cover 2. Hook
NOTICE:
When opening the wheel cover, open
and release both the hooks simultaneously.
Opening only one hook may cause crack on the
wheel cover.
8 ENGLISH
1
2
2

Advertisement

Table of Contents
loading

Table of Contents