uuOperating the Switches Around the Steering WheeluAuto High-Beam
■
Manual switching between high-beam and low-beam
If you want to manually switch the headlights between high beam and low beam,
follow either of the procedures below. Note that when you do this, the auto high-
beam indicator will turn off and the auto high-beam will be deactivated.
Using the lever:
Pull the lever toward you for flashing the high beams then release it within about
one second while driving.
To reactivate the auto high-beam, pull the lever toward you for flashing the
u
high beams then release it while driving. The auto high-beam indicator will
come on.
Using the light switch:
Turn the light switch to
u
To reactivate the auto high-beam, turn the light switch to AUTO when the
lever is in the low beam position, the auto high-beam indicator will come on.
188
.
1How to Use the Auto High-Beam
If the Some Driver Assist Systems Cannot
Operate: Camera Temperature Too High message
appears:
•
Use the climate control system to cool down the
interior and, if necessary, also use defroster mode
with the airflow directed toward the camera.
•
Start driving the vehicle to lower the windshield
temperature, which cools down the area around
the camera.
If the Some Driver Assist Systems Cannot
Operate: Clean Front Windshield message
appears:
•
Park your vehicle in a safe place, and clean the
windshield. If the message does not disappear after
you have cleaned the windshield and driven for a
while, have your vehicle checked by a dealer.