Device Address - Ebyte MA01-AXCX4020 User Manual

Wireless modem

Hide thumbs Also See for MA01-AXCX4020:

Table of Contents

Chengdu Ebyte Electronic Technology Co., Ltd.

4.2.2 Switch output DO mode setting

(1) Level mode

Output according to the level set by the user. The switching characteristics of the level mode are

similar to the function of a self-locking switch.

(2) Pulse mode

After the switch output DO is turned on, the set pulse width time (in ms) is maintained, and the

switch output DO is automatically turned off. The pulse width setting range is 50～65535 (default

50).

(3) Follow mode

After the user sets the follow mode, set the follow input terminal. The switch output DO

terminal is consistent with the DI input terminal.

Note: Multiple switch output DO terminals can be set to follow one DI input terminal, and one

switch output DO terminal can not be set to follow multiple DI input terminals.

4.3 Device address

4.3.1 Device address

Device address composition: hardware address + software offset address

The default device address is: 1 (hardware address 0 + software address 1 = device address 1).

Device address setting range: 1～247.

Hardware address: realized by the dial switch (5 digits) dial setting (the factory default is 0).

Software address: It is realized by the "offset address" set by the configuration tool software (the

factory default is 1).

For example:

If the hardware address is set to 5 and the software address is set to 113, the device address is 118.

Figure 4-3-1 Device address

【4DI+2DO】MA01-AXCX4020 User Manual

Table of Contents