8
How to use advanced functions
8.7
FP function (Freezing protection)
2
C
Note: This function is for heat pump air conditioner only.
Press this button 2 times during one second under HEAT Mode and setting temperature of 16 °C/60 °F
to activate FP function.
Press On/Off, Sleep, Mode, Fan and Temp. button while operating will cancel this function.
8.8
LOCK function
5s
+
Go
Clean
8.9
SET function
SET
• Press the SET button to enter the function setting, then press SET button or TEMP
button to select the desired function. The selected symbol will flash on the display area, press the OK
button to confirm.
• To cancel the selected function, just perform the same procedures as above.
24 / 80 EN
The unit will operate at high fan speed (while compressor on) with
temperature automatically set to 8 °C/46 °F.
5s
Press together GoClean button and Turbo button at the
same time more than 5 seconds to activate Lock function.
Turbo
All buttons will not response except pressing these two
buttons for two seconds again to disable locking.
SET
or
or TEMP
Remote control / User Manual
OK