SMC Networks ASP Series Instruction Manual page 2

AS-TF222-156EN
7 Maintenance
7.1 General maintenance
Caution
• Not following proper maintenance procedures could cause the product to
malfunction and lead to equipment damage.
• If handled improperly, compressed air can be dangerous.
• Maintenance of pneumatic systems should be performed only by qualified
personnel.
• Before performing maintenance, turn off the power supply and be sure to cut
off the supply pressure. Confirm that the air is released to atmosphere.
• After installation and maintenance, apply operating pressure and power to
the equipment and perform appropriate functional and leakage tests to make
sure the equipment is installed correctly.
• If any electrical connections are disturbed during maintenance, ensure they
are reconnected correctly and safety checks are carried out as required to
ensure continued compliance with applicable national regulations.
• Do not make any modification to the product.
• Do not disassemble the product, unless required by installation or
maintenance instructions.
8 Limitations of Use
Warning
• The system designer should determine the effect of the possible failure
modes of the product on the system.
• The system assembler should determine the reaction time of the system.
8.1 Limited warranty and disclaimer/compliance requirements
Refer to Handling Precautions for SMC Products.
8.2 Effect of energy loss on valve switching
Caution
When the air pressure is cut, the valve closes.
9 Product Disposal
This product shall not be disposed of as municipal waste. Check your local
regulations and guidelines to dispose this product correctly, in order to reduce
the impact on human health and the environment.
10 Contacts
Refer to www.smcworld.com or www.smc.eu for your local distributor/importer.
URL : https:// www.smcworld.com (Global) https:// www.smc.eu (Europe)
SMC Corporation, 4-14-1, Sotokanda, Chiyoda-ku, Tokyo 101-0021, Japan
Specifications are subject to change without prior notice from the manufacturer.
© 2023 SMC Corporation All Rights Reserved.
Template DKP50047-F-085M
Page 2 of 2