Stamina 15-7250B Owner's Manual page 9

ASSEMBLY INSTRUCTIONS
STEP 6
Attach the SEAT FRAME(114) to the SEAT CARRIAGE(7) with BUTTON HEAD BOLTS(M10x1.5x200mm)
(76), WASHERS(M10)(99), LOCK WASHERS(M10)(101), and ACORN NUTS(M10x1.5)(97).
NOTE: The four attachment holes on each side of the SEAT FRAME(114) allow the SEAT FRAME(114) to
be attached in two different positions: one to position you closer to the HANDLEBAR(4) and one
further away. At this point of assembly, use the holes at the back so the Seat Assembly is closer to
the HANDLEBAR(4). After all assembly steps, refer to page 14 for the details of seat adjustment.
STEP 7
NOTE: The PULSE SENSOR WIRES(55) go through the tube of the HANDRAIL(9). Be careful not to
damage the wires with the BUTTON HEAD BOLTS(M8x1.25x45mm)(71) when attaching the
HANDRAIL(9) to the SEAT CARRIAGE(7).
To attach the HANDRAIL(9), position the HANDRAIL(9) under the SEAT CARRIAGE(7) as shown in the
above illustration and secure with BUTTON HEAD BOLTS(M8x1.25x45mm)(71), ARC WASHERS(M8)
(98), and LOCK WASHERS(M8)(100).
STEP 8
Refer to the inset drawing. Plug the PULSE SENSOR WIRE(55) into the SOCKET of the PULSE EXTENSION
WIRE(43) located on the SEAT RAIL(45).
Socket of Pulse
Extension Wire(43)
9
Use this set of attachment
holes for assembly.