Table of Contents
Advertisement
5.
USB 2.0 connectors (10-1 pin USB_E12, USB_E34)
These connectors are for USB 2.0 ports. Connect the USB module cable to this
connector, then install the module to a slot opening at the back of the system chassis.
These USB connectors comply with USB 2.0 specification that supports up to 480
Mbps connection speed.
J1800M-A
J1900M-A
J1800M-A/J1900M-A USB2.0 connectors
Never connect a 1394 cable to the USB connector. Doing so will damage the motherboard!
The USB module cable is purchased separately.
6.
Serial ATA 3.0Gb/s connectors (7-pin SATA3G_1/2)
These connectors connect to Serial ATA 3.0 Gb/s hard disk drive or optical drive via
Serial ATA 3.0 Gb/s signal cables.
J1800M-A
J1900M-A
J1800M-A/J1900M-A SATA 3.0Gb/s connectors
•
To configure the default SATA type in BIOS, click Advanced Mode > Advanced tab >
SATA Configuration > SATA Mode.
•
When using hot-plug and NCQ, set the SATA Mode item in the BIOS to [AHCI Mode].
See section 2.5.3 SATA Configuration for details.
ASUS J1800M-A / J1900M-A
USB_E12
USB_E34
PIN 1
PIN 1
SATA3G_1
SATA3G_2
1-13
Advertisement
Table of Contents
