Intended Use; Technical Data; Before Starting The Equipment - EINHELL TE-OS 18/230 Li Original Operating Instructions

18V 4.0Ah/6.0Ah P-X-C Plus lithium-ion battery
18V P-X-C Dual Port Fast Charger
18V P-X-C Fast Charger
Explore battery + charger options at
einhellUSA.com

3. Intended use

The equipment is designed for the sanding of
wood, iron, plastic and similar materials using the
appropriate sanding paper. The equipment is not
suitable for wet sanding.
The equipment is allowed to be used only for its
prescribed purpose. Any other use is deemed to
be a case of misuse. The user/operator and not
the manufacturer will be liable for any damage or
injuries of any kind resulting from such misuse.
Please note that our equipment has not been
designed for use in commercial, trade or
industrial applications. Our warranty will be voided
if the equipment is used in commercial, trade or
industrial businesses or for equivalent purposes.

4. Technical data

Motor power supply: ............................18 V
No-load OPM ................................ 14.000-22.000
No-load speed .............. 7.000-11.000 rpm (min
Orbit diameter: .............................0.1 in. (2.5 mm)
SIZE OF PAPER:
Hook and Loop:
..................... / Sheet / 9 x 4.5 in. (230 x 115 mm)
1
2
Clamp: ......................11 x 4.5 in. (280 x 115 mm)
Weight (Tool only): ........................ 4.4 lbs (2.0 kg)
Wear ear-muff s.
The impact of noise can cause damage to
hearing.
Reduce noise generation and vibration to a
minimum!
•
Use only equipment that is in perfect
condition.
•
Maintain and clean the equipment regularly.
•
Adapt your way of working to the equipment.
•
Do not overload the equipment.
Anl_TE_OS_18_230_Li_USA_SPK7.indb 12 Anl_TE_OS_18_230_Li_USA_SPK7.indb 12
EN
•
Have the equipment checked if necessary.
•
Switch off the equipment when not in use.
•
Wear gloves.
CAUTION!
Residual risks
Even if you use this electric power tool in
accordance with the instructions, certain
residual risks cannot be eliminated. The
following hazards may arise in connection
with the equipment's construction and
layout:
1. Lung damage if no suitable protective dust
mask is used.
2. Damage to hearing if no suitable ear
protection is applied.
3. Health damage caused by hand-arm
vibrations if the equipment is used over a
longer period or is not properly guided and
maintained.
Limit the operating time.
All stages of the operating cycle must be
considered (for example, times in which the
electric tools are switched off and times in which
the tool is switched on but operates without load).

5. Before starting the equipment

Warning!
Always remove the battery pack before making
adjustments to the equipment.
)
-1
Be sure to read the following information before
you put the cordless equipment into operation:
•
Charge the battery pack with the charger. If
a rechargeable battery is empty, it must be
recharged before you use the equipment for
the first time.
5.1 Fitting the dust collection box (Fig. 2)
The dust collection bag (3) must be pushed onto
the dust exhaust port for the dust collection box
(7).
To remove the dust collection bag (3), pull the
dust collection bag to the rear and off .
The dust is extracted directly into the dust
collection bag through the abrasive paper and the
oscillating plate.
- 12 -
25.08.2021 16:03:10 25.08.2021 16:03:10