Intended Use; Technical Data; Before Starting The Equipment - EINHELL TE-OS 18/1 Li Original Operating Instructions

3. Intended use

The equipment is designed for the sanding of
wood, iron, plastic and similar materials using the
appropriate sanding paper. The equipment is not
suitable for wet sanding.
The equipment is allowed to be used only for its
prescribed purpose. Any other use is deemed to
be a case of misuse. The user/operator and not
the manufacturer will be liable for any damage or
injuries of any kind resulting from such misuse.
Please note that our equipment has not been
designed for use in commercial, trade or
industrial applications. Our warranty will be voided
if the equipment is used in commercial, trade or
industrial businesses or for equivalent purposes.

4. Technical data

Motor power supply: ............................18 V
Idling speed: ........................... 12000 min
Sanding/grinding area: ........................................
................5.9 x 5.9 x 3.9 in. (150 x 150 x 100 mm)
Abrasive paper size (hook-and-loop fastener): ....
....................3.6 x 2.4 x 4.1 in. (93 x 60 x 105 mm)
Oscillatory circuit Ø: ................. 0.06 in. (1.6 mm)
Weight: ......................................... 1.5 lbs (0.7 kg)
Wear ear-muff s.
The impact of noise can cause damage to
hearing.
Reduce noise generation and vibration to a
minimum!
•
Use only equipment that is in perfect
condition.
•
Maintain and clean the equipment regularly.
•
Adapt your way of working to the equipment.
•
Do not overload the equipment.
•
Have the equipment checked if necessary.
•
Switch off the equipment when not in use.
•
Wear gloves.
TE_OS_18_1_Li_Kit_USA_SPK7.indb 12 TE_OS_18_1_Li_Kit_USA_SPK7.indb 12
EN
CAUTION!
Residual risks
Even if you use this electric power tool in
accordance with the instructions, certain
residual risks cannot be eliminated. The
following hazards may arise in connection
with the equipment's construction and
layout:
1. Lung damage if no suitable protective dust
mask is used.
2. Damage to hearing if no suitable ear
protection is applied.
3. Health damage caused by hand-arm
vibrations if the equipment is used over a
longer period or is not properly guided and
maintained.
Limit the operating time.
All stages of the operating cycle must be
considered (for example, times in which the
electric tools are switched off and times in which
the tool is switched on but operates without load).
(rpm)
-1

5. Before starting the equipment

Warning!
Always remove the battery pack before making
adjustments to the equipment.
Be sure to read the following information before
you put the cordless equipment into operation:
•
Charge the battery pack with the charger. If
a rechargeable battery is empty, it must be
recharged before you use the equipment for
the first time.
5.1 Fitting the dust collection box (Fig. 2-3/
Item 4)
•
Plug the dust collection box (4) onto the
vacuum cleaner connector.
•
The dust is extracted directly into the dust
collection box through the abrasive paper and
the oscillating plate (5).
•
To empty the dust collection box, open the
box as shown in Fig. 3 and carefully empty it
by tapping.
5.2 Fitting the dust extractor adapter (Fig. 5/
Item 2)
Plug the dust extractor adapter (2) onto the
vacuum cleaner connector as shown in Fig. 5.
Connect the dust extractor adapter to a suitable
dust extraction system.
- 12 -
14.01.2019 14:03:52 14.01.2019 14:03:52