Palm-Rest And Keyboard Assembly; Removing The Palm-Rest And Keyboard Assembly - Dell XPS 15 9530 Service Manual

Steps
1. Place the LED board on the system board following the routing guide on the palm-rest and keyboard assembly.
NOTE: Ensure the LED-board bracket is aligned with the pegs on the palm-rest and keyboard assembly.
2. Adhere the LED-board cable to the palm-rest and keyboard assembly.
3. Connect the LED-board cable to the system board and close the latch to secure the cable.
Next steps
1. Install the speakers.
2. Install the battery.
3. Install the base cover.
4. Follow the procedure in

Palm-rest and keyboard assembly

Removing the palm-rest and keyboard assembly

Prerequisites
1. Follow the procedure in
2. Remove the base cover.
3. Remove the battery.
4. Remove the speakers.
5. Remove the memory module.
6. Remove the solid state drive
7. Remove the solid state drive
8. Remove the heat sink.
NOTE: The system board can be removed or installed together with the heat sink attached. This simplifies the
procedure and avoids breaking the thermal bond between the system board and the heat sink.
9. Remove the right fan.
10. Remove the left fan.
50 Removing and installing components
After working inside your
Before working inside your
1.
2.
computer.
computer.