Yamaha YZFR7P Owner's Manual page 29

Turn signal switch " /
To signal a right-hand turn, push this
switch to " ". To signal a left-hand
turn, push this switch to "
released, the switch returns to the cen-
ter position. To cancel the turn signal
lights, push the switch in after it has re-
turned to the center position.
Horn switch " "
Press this switch to sound the horn.
Engine stop switch " /
Set this switch to " " (run) before
starting the engine. Set this switch
to " " (stop) to stop the engine in case
of an emergency, such as in the event
of an overturn or if the throttle is stuck.
Start switch " "
Push this switch to crank the engine
with the starter. See page 6-2 for start-
ing instructions prior to starting the en-
gine.
EAU12461
" Hazard switch "OFF/ "
Use this switch to turn on the hazard
lights (simultaneous flashing of all turn
". When signal lights). The hazard lights are
used in case of an emergency or to
warn other drivers when your vehicle is
stopped where it might be a traffic haz-
ard.
The hazard lights can be turned on or
EAU12501 off only when the main switch is in the
"ON" position. You can turn the main
switch to the "OFF" or "LOCK" posi-
tion, and the hazard lights will continue
EAU12664
" to flash. To turn off the hazard lights,
turn the main switch to the "ON" posi-
tion and operate the hazard switch
again.
NOTICE
Do not use the hazard lights for an
EAU12713 extended length of time with the en-
gine not running, otherwise the bat-
tery may discharge.
Instrument and control functions
EAU88273
"SEL/RES" switch
This switch is used to make setting and
display changes in the multi-function
meter unit. See page 4-4 for more in-
formation.
To use the "SEL" switch, move the
"SEL/RES" switch in direction (a). To
use the "RES" switch, move the
"SEL/RES" switch in direction (b).
ECA10062
1. "SEL/RES" switch
4-11
EAU88941
4
(b) (b) (b)
1 1 1
(a) (a) (a)