Advertisement
Dometic 8700 Series MasterFlush Toilet
11 . Loosen band clamp on discharge loop outlet and remove discharge adapter fitting/hose
fitting assembly (fig .
12 . Lubricate discharge fitting assembly and inside end of discharge hose with liquid dishwashing
soap . Push discharge fitting assembly into discharge hose and connect with two hose clamps .
Be sure to position hose clamp screws 180° apart from each other (fig .
access holes and floor brackets .
13 . Connect toilet water line and 4-pin connector to water supply line and control module cable .
14 . Position toilet over floor brackets and tilt toilet up from back . Push discharge assembly fitting
and hose up into discharge loop outlet . Lower toilet to floor and tighten band clamp (fig .
15 . Turn on water supply and electrical power to toilet, and check for leaks . Press "Flush" switch
(fig .
2, page 2) . If leak occurs, tighten connection .
4
16 . At floor mounting holes, drill pilot holes for hex-head floor fasteners . Install fasteners and
washers using a 3/8 in . (10 mm) socket wrench (fig .
17 . Cover floor fasteners with plastic covers (fig .
12
15
13
) .
13
16
16
) .
17
) .
Installation
14
) . Place toilet near
14
17
15
) .
9
Advertisement
