Subaru Crosstrek 2017 Owner's Manual page 112

2-14
Keys and doors/Keyless access with push button start system
1) LED indicator
When the access key is within either of the
operating ranges of the front doors, the
LED indicator on the access key flashes.
When the keyless access functions are
disabled, the LED indicator does not flash
unless a button on the access key is
pressed.
Operating range tips
Regarding malfunction:
The keyless access function may not
operate properly due to the following
reasons.
. The access key is placed too close to
the vehicle body (in this case, repeat the
operation from further away).
. The access key is placed near the
ground or in an elevated location from the
ground, even if it is in the indicated
operating range.
. The status of the access key and the
radio wave conditions around the vehicle
(e.g., access key battery discharge) (in
this case, perform the procedure de-
scribed in Locking and unlocking
17).
Precautions:
. When the access key is within the
operating range, it is possible for anyone,
even someone who is not carrying the
access key, to operate the keyless access
function. Please note that the keyless
access function is only available for the
following items when the access key is
detected within operating range.
Door handle
Door lock sensor
Rear gate opener button
Rear lock button
. It is not possible to lock the doors and
rear gate using the keyless access func-
tion when the access key is inside the
vehicle. However, depending on the status
of the access key and the environmental
conditions, the access key may be locked
inside the vehicle. Before locking the
doors and rear gate, make sure that you
have the access key.
. The operating range may be reduced,
or the keyless access function may not
operate in the following cases:
When the battery of the access key
is discharged
When the access key is in a
location with strong radio waves or
9- noise (e.g., near a radio tower, power
plant, broadcast station or an area
where wireless equipment is used)
While talking on a cell phone
In such a case, perform the procedure
described in Locking and unlocking
9-17.
. When an access key is in the operating
range, if the door handle becomes wet
due to exposure to a significant amount of
water when the vehicle is washed or
during heavy rain, the doors may be
locked or unlocked.
How to use keyless access func-
tions
Keyless access function tips
. Turn off the push-button ignition switch
before locking the doors (including rear
gate) using the keyless access function. It
is not possible to lock the doors (including
the rear gate) using the keyless access
function when the push-button ignition
switch is on the ACC or ON position.