Skew/Side Position Adjustment (Printer Unit) - Panasonic DP-150 Service Manual

2. Skew/Side position adjustment (Print unit)
Position
Set value Adjustment
-4 Move left by 2.0 mm.
-3 Move left by 1.5 mm.
-2 Move left by 1.0 mm.
-1 Move left by 0.5 mm.
0 0.0 mm
1 Move right by 0.5 mm.
2 Move right by 1.0 mm.
3 Move right by 1.5 mm.
3-30
Adjustment
Skew adjustment
When the skew copy is not fixed by the tray
adjustment, follow the instruction below.
1 Load LETTER/A4 paper in the sheet bypass.
5mm
2
Enter F8 in the service mode.
3 Select the "F8-C50" mode and press Start
key.
4 Make sure if the skew occurs.
5 Check each paper tray.
If you find the skew at the other trays,
6
select "F6-C41 to C42" corresponding to
the tray and adjust the loop length at the
registration.
Side position adjustment
(Electric adjustment)
Attention: Follow the instruction below
ONLY WHEN the side position
is not adjusted correctly by the
auto adjustment.
Perform the procedure
1
Measure the interval between the left end
2
of the paper and the black line at the left
end.
Adjust the value of "F6-C84" following the
3
procedure below.
The interval is less than 5 mm : enter the
4
positive value (+) according to the table
below.
The interval is more than 5 mm : enter the
5
negative value (–) according to the table
below.
to above.
1 3