Keysight EDU190A Operating Instructions

Instrument stacking kit

Keysight EDU190A Instrument Stacking Kit

Operating Instructions

This stacking kit is designed for use with Keysight EDU34450A digital multimeter, Keysight EDU33210 Series arbitrary

waveform generator and Keysight Inﬁ niiVision 1000-X Series oscilloscopes.

Parts

A: Stack Cover - Top

5190-9165 (x1)

E: M5x10mm Phillips Pan Head Screws

0515-6575 (x11)

Phillips head screwdriver

Attach the side stack cover (C) to bottom stack cover (B). Tighten with 2 screws (E) using Phillips head screwdriver.

Repeat the same step for the other side.

Put the top stack cover (A) above the assembled item in Step 1, as shown below. Tighten with 2 screws (E) using Phillips

head screwdriver. Repeat the same step for the other side. Ensure all the screws are ﬁ rmly tighten.

B: Stack Cover - Bottom

5190-9167 (x1)

F: Pozi Flat Countersunk Self-Taping Screw

0515-6574 (x1)

C: Stack Cover – Side

D: Stack Cover – L Bracket

5190-9166 (x2)

G: Nylon Plug

0590-3410 (x1)

5190-9168 (x1)

Table of Contents

Do you have a question about the EDU190A and is the answer not in the manual?

Page 1 Keysight EDU190A Instrument Stacking Kit Operating Instructions This stacking kit is designed for use with Keysight EDU34450A digital multimeter, Keysight EDU33210 Series arbitrary waveform generator and Keysight Inﬁ niiVision 1000-X Series oscilloscopes. Parts A: Stack Cover - Top B: Stack Cover - Bottom C: Stack Cover –...
Page 2 Stack up to 2 sets of single stacking kit and tighten with 2 screws (E) at the rear ﬂ ange. Install L-bracket (D) to the rear of the stacking kit with one screw (E) and mount it to the wall with self-taping screw (F). © Keysight Technologies 2020 Printed in Malaysia...