Advertisement
Operating Manual
TM
Half Bridge Strain Gage Measurements
The model 142 can be wired for half bridge strain gage measurements if required. For this configuration,
the completion resistor will need to be replaced with a 0Ohm value. The wiring configuration for this
option is illustrated in the schematic below.
0Ohm completion resistor
Measurement Specialties, Inc.
www.meas-spec.com
+1 949-716-5377
32 Journey, Suite 150, Aliso Viejo, CA 92656 USA
9 of 11
t&m@meas-spec.com
Advertisement
