Pro-Form PFEL69720-INT.3 User Manual page 10

9. Apply grease to a Pedal Arm Axle (64).
Insert the Pedal Arm Axle (64) into the Right
Upper Body Leg (60) and the Right Pedal
Arm (58) from the direction shown.
Next, slide an M8 x 22mm Washer (14) onto an
M8 x 13mm Screw (82), and tighten the Screw a
few turns into the Pedal Arm Axle (64).
Then, tighten the Pedal Arm Axle (64) and the
M8 x 13mm Screw (82) at the same time.
Repeat this step on the other side of the
elliptical.
10. Untie and discard the wire tie on the Upper
Wire (110).
While a second person holds the Console (7)
near the Upright (4), plug the Upper Wire (110)
into the receptacle on the Console.
The connector on the Upper Wire (110)
should slide easily into the receptacle and
snap into place with an audible click. If the
connector does not slide easily into the recep-
tacle, turn the connector and try again. If you
do not connect the connector properly, the
Console (7) may become damaged when you
use the elliptical.
Insert the excess wire into the Upright (4) or into
the Console (7).
Tip: Avoid pinching the Upper Wire (110).
Attach the Console (7) to the Upright (4) with
four #8 x 5/8" Screws (101); start all the
Screws, and then tighten them.
9
10
7
101
10
82
60
14
64
Grease
58
Avoid pinching the
Upper Wire (110)
110
4
101