Panel Facilities - Pioneer PRO-730HD Service Manual

1

8. PANEL FACILITIES

A
Front
A flip-down door conceals the INPUT 4 jacks. Push gently
and release, to open the door. To close the door, lift it
back up into place.
NOTE:
If you accidentally pull the door, it may not shut properly. Push
the door back in to shut it.
1 POWER STANDBY/ON indicators
red: STANDBY
green: when lit; ON
B
when flashing; power management in operation
2 ROOM LIGHT SENSOR (RLS)
Sensor to detect the room brightness.
C
D
1
E
ON
STANDBY
F
250
1
2
2
ROOM LIGHT
SENSOR
PRO-730HD
2
3
3 MAIN POWER
If the button is OFF, the power of the monitor is shut off
and 4 STANDBY/ON button on the receiver or TV power
on the remote control will not function. Pressing the button
again will turn the monitor ON and the monitor enters the
standby mode. In the standby mode, you can turn on the
monitor using the 4 STANDBY/ON button on the monitor
or TV power on the remote control.
4 POWER (
STANDBY/ON) button
Switches the monitor between on and standby (note that
the monitor consumes a small amount of power (0.5 W) in
standby mode.
5 INPUT SELECT and SET button
Press to select your program source. Each press of the
INPUT SELECT button changes the selection to the next
source.
INPUT6
INPUT5 INPUT4
While the menu is displayed, it performs the same
operation as the SET/ENTER button on the remote
control.
6 CHANNEL + , - and | , \ buttons
Press plus (+) or minus (-) to tune to a higher or lower
channel. Only the preset channels can be tuned in using
these buttons.
Press to select or adjust items on the menu screen.
7 MENU button
Press to turn the menu on.
Press again to return to normal TV screen.
8 VOLUME +, - and »,«buttons
Press plus (+) button to increase the volume, press minus
(-) button to decrease it.
Press to select or adjust items on the menu screen.
3 4
MAIN POWER
STANDBY/ON
POWER
MENU
ACCESS
3
4
(OFF/ON) button
TV INPUT1
INPUT3 INPUT2
5 6 7
SELECT
INPUT CHANNEL MENU
SET MENU
4