Pioneer PRO-730HD Service Manual page 172

5
6
ACL Adjustment
-4
Start
1st FAC
AUTO ACL ADJUST
SUB CH
START ?
Signal:
• Input a cross hatch of composite signal into an INPUT4 connector.
Conditions:
• When there is the cross hatch of composite signal, be sure to adjust.
• When there is not a cross hatch of composite signal and replaces the EEPROM IC, this adjustment is unnecessary.
• When there is not a cross hatch of composite signal and does not replace the EEPROM IC, input a value of "45".
(Method refers to the following.)
• When perform the above adjustment, and display "END NG", input a value of "45". (Method refers to the following.)
Start
1st FAC
AUTO ACL ADJUST
SUB CH
START ?
5
6
Perform this adjustment after the white balance adjustment by all means.
< Data value >
VOL
Data value
PRO-730HD
6
7
Several seconds AUTO ACL ADJUST
later
1
END OK
5
or
7
8
AUTO ACL ADJUST
EEPROM WRITE! 45
Data value: 45
171
8
A
B
C
D
E
F