Installing The Canopy; Installing The Blades - Hunter Dublin Installation Manual

Place the receiver inside the
canopy. Ensure the wires
remain connected.
Partially install a canopy screw, found
in the hardware bag, between
the ceiling plate hooks. When all the
holes are properly aligned, securely
tighten all three canopy screws.
Note:
Fan style may vary.
Note:
Fan style may vary.
Ceiling Bracket Hanging Fan

Installing the Canopy

Swing the fan up to align the
canopy screw holes with the
mounting holes on the ceiling plate.
Note: The slots in
the canopy must
remain engaged while
swinging the canopy
for alignment.
Ceiling Plate Hooks
Canopy
bag Screws

Installing the Blades:

IMPORTANT
NOTE: Follow the instructions on the blade. Installing it
incorrectly could result in your fan not functioning.
Wiring
Hold the canopy up with the screw holes
aligned. Partially install two canopy screws,
found in the
holes opposite the ceiling plate hooks.
1 of 3
Using both hands, push the canopy trim
ring up to the top of the canopy. The canopy
trim ring will snap and lock into place.
Note: Should you need to remove the trim ring,
press firmly on opposite sides of the trim ring. The
tabs will flex out releasing the canopy trim ring.
Insert the blade into the blade slot around the
center screw. Put the blade washers found in
the hardware bag onto the blade screws
found in the hardware bag. Then install
the blade screws to secure each blade to
the fan.
Repeat x3
Canopy Blades
bag
hardware bag, into the
WARNING
FAN FALL HAZARD
Make sure screws are tight.
bag
bag
Light Bulbs
1886
2 of 3
Canopy
Screws
x6
Blade Screw
x6
Blade Washer
6
Remote