Troubleshooting - BOMANN SBS 7344 Instruction Manual

Changing the light
CAUTION:
Do NOT remove the cover of the light. The LED light
may be replaced / repaired in case of failure / defect
only by an authorized specialist.
Replacing the door hinge
If the appliance door starts to stutter, crack or jam
when you open it, it is probably due to a worn or
damaged hinge.
It is recommended to replace all door hinges at the
same time, otherwise the next repair will soon be
beckoning.
• Remove the contents of the appliance and the
movable interior parts.
• Tilt the appliance backwards and block it in this
position to prevent the door from sliding out.
• Loosen the hinge cover and disassemble the
upper door hinge.
• If necessary, first turn out the stand and disas-
semble the lower door hinge.
• The respective hinge assembly is carried out in
reverse order.
• Open and close the appliance door for a test run,
readjust the hinges if necessary. In any case,
make sure that the door fits tightly and accurately.

Troubleshooting

Before you contact an authorized specialist
Problem / cause / action
Appliance is not working properly or at all
- Check the power supply / temperature setting /
ambient temperature.
- Unblock the ventilation openings, install the ap-
pliance freely.
Loading is too warm
- Check the temperature setting / ambient temper-
ature.
- A large quantity of warm food has been stored in
the unit in the last 24 hours.
- The appliance door is not closed properly, check
the door seal.
Loud noise during operation
- Check that the appliance is level.
"Operating noise"
- See
Water on the appliance bottom
- Check the temperature setting.
Light does not work
- Check the power supply.
"Changing the light"
- See
Error codes
With some malfunctions, the display shows error
codes!
Code Causes
E0 Display communication failure
E1 Temperature sensor failure fridge section
E2 Temperature sensor failure freezer section
E3 Defrosting sensor failure
E5 Defrost heater failure
NOTE:
If a problem persists after following the steps above,
contact your trader or an authorized technician.
30
.
.