Failure Display And Inspection - Hoover H-HOB 700 HIFS954SC Instructions For Use And Installation

The induction hob or a
cooking zone has
turned itself off
unexpectedly, a tone
sounds and an error
code is displayed
(typically alternating
with one or two digits
in the cooking timer
display).

Failure Display and Inspection

If an abnormality comes up, the induction hob will enter the protective state
automatically and display corresponding protective codes:
Problem Possible causes
F1-F6 Temperature sensor failure
F9-FA
Temperature sensor of the IGBT
failure.
Fb
The connection between the
right display board and the
middle display board
FC
The connection between the
display board and the main
board is fail
E1/E2 Abnormal supply voltage
E3/E4 Temperature sensor of the
ceramic glass plate Is high
E5 Temperature sensor of the IGBT
Is high
if there are anyone zone of the flexible area
area
selection control will not be able to use。
The above are the judgment and inspection of common failures.
Technical fault. Please note down the error
letters and numbers, switch
the power to the induction hob
off at the wall, and contact a
qualified technician.
What to do
Please contact the supplier.
Please contact the supplier.
Please contact the supplier.
Please contact the supplier.
Please inspect whether power
supply is normal.
Power on after the power
supply is normal.
Please restart after the
induction hob cools down.
Please restart after the
induction hob cools down.
to be protected，
the flexible