Advertisement
5.
Enter exit to exit the Ethernet interface commands and return to the Global Configuration mode.
6.
Enter ip route 0.0.0.0 0.0.0.0 192.168.1.254 to add a default route to the route table. 0.0.0.0 is the default
route and the default subnet mask, and 192.168.1.254 is the next-hop IP address to which the AOS unit
should send all of its traffic. You will need to enter the proper route, subnet mask, and gateway for your
network. This information is typically provided by an Internet service provider (ISP) or local network
administrator.
7.
Enter do write memory to save the current configuration.
E
T
NABLE
ELNET
The following steps enable user login parameters for Telnet access by changing the password from the default
(password) and enabling security login on Telnet lines.
1.
Verify that the prompt of your unit displays (config)#.
2.
Enter line telnet 0 4 to change the configuration parameters for the Telnet sessions.
3.
Enter login to prompt users with a login prompt for Telnet access.
4.
Enter password adtran to change the login password for the Telnet sessions.
5.
Enter exit to return to the Global Configuration mode.
6.
Verify that the prompt of your unit displays (config)#.
7.
Enter do write memory to save the current configuration.
C
Y
ONFIGURE
OUR
The applications you will need to configure vary by product and by network. Review the list of defaults for your
unit before deciding what applications to configure. The following are some common applications that should be
configured on startup. These are all available online at http://kb.adtran.com.
Configuring T1 Access to a Remote Site Using
PPP in AOS (video article 2003)
Configuring Port Forwarding in AOS
(video article 2291)
Configuring PPP in AOS (article 2523)
Configuring Frame Relay in AOS
(article 2350)
Configuring DHCP Server in AOS
(article 2149)
Configuring a VPN Using Aggressive Mode in
AOS (article 1926)
Configuring Switchboards and Dial Plans in
AOS (article 2130)
Configuring Enhanced ANI/DNIS Substitution
in AOS (article 2509)
Important: For additional details on product features, specifications, installation,
and safety, refer to the appropriate hardware installation guide available on the AOS
Documentation CD shipped with the base unit and online at http://kb.adtran.com.
Quick Start Guide, 64240916L1-13D, May 2010
U
L
A
SER
OGIN
A
PPLICATION
CCESS
Configuring Internet Access (Many to One NAT) with
the Firewall Wizard in AOS (video article 2185)
Configuring QoS for VoIP in AOS
(video article 3091)
Configuring HDLC in AOS (article 2152)
Configuring QoS in AOS
(article 1617)
Configuring a VPN Using Main Mode in AOS
(article 1925)
Configuring Voice Traffic over SIP Trunks in AOS
(article 3395)
Configuring PRI Signaling for DSX-1 in AOS
(article 3396)
Configuring Source and ANI Based Routing in AOS
(article 2510)
3
Advertisement
