DSC MAXSYS PC4020 Instruction Manual page 10

Disarming Another Partition
If you have a multi-partition access code, you can disarm other partitions
before entering them. To disarm another partition, enter your access code.
The keypad display will read:
(0) TO ARM
(Partition Label) R
Use the arrow (< >) keys to scroll to the partition you wish to disarm.
Remember that only partitions to which your access code is assigned will
be displayed. If the partition you have selected is armed, the letter "A"
will appear on the bottom right-hand corner of the display, as in the
following example:
(2) TO SELECT < >
(Partition Label) A
To disarm the partition, press the number in parentheses (in this case, [2])
or press the [✱] key.
Group Bypassing
If your system is setup for group bypassing you will be allowed to bypass
a group of zones while the system is 'armed or disarmed'.
When the system is 'disarmed' the keypad will display:
'Secure System
'Before Arming < >'
or
'Enter Code to
Arm System < >'
If the system is armed, the keypad will display:
' Enter Code To
' Disarm System < >'
Press the (< >) keys until the display shows the group you wish to bypass,
usually your installer will program an appropriate label to define your
group of zones to make it easier. For example, if you have a bedroom that
is setup for group bypassing the keypad could display:
' ✱ To Bypass < >
Bedroom 1'
or if the label says 'Safe' :
' ✱ To Bypass <>
Safe'
8
< >