Haier HOA-P10PW4X Instruction Manual page 48

INSTALLATION
Adjust the position of the oven door
Adjustment mechanism allows you to change
the height of right side of the oven door
as limited by its design. Oven door height
adjustment on one side allows you to level
the door and align it with the control panel.
Adjustment method
l Loosen the nut [1] with size 13 open-end
wrench.
l Use size 4 Allen key to rotate adjustment
spindle [2] within 180° range to obtain the
correct door position. The door position
will be adjusted in the ±1.5 mm range.
l Tighten the lock nut [1] while holding the
adjustment spindle [2] in position using
the Allen key.
1
2
48
Electrical connection
l The oven is manufactured to work with
a one-phase alternating current (230V
1N~50 Hz) and is equipped with a 3
x 1,5 mm connection lead of 1.5 mm
2
length with a plug including a protection
contact.
l A connection socket for electricity supply
should be equipped with a protection
pin and may not be located above the
cooker. After the cooker is positioned, it is
necessary to make the connection socket
accessible to the user.
l Before connecting the oven to the socket,
check if:
- the fuse and electricity supply are able to
withstand the cooker load,
- the electricity supply is equipped with an
efficacious ground system which meets
the requirements of current standards
and provisions,
- the plug is within easy reach.
Important!
If the fixed power supply cable is damaged,
it should be replaced at the manufacturer
or at an authorized servicing outlet, or by a
qualified person to avoid danger.