Rear Wheel - Yamaha Star XV250G 2015 Owner's Manual

Rear wheel

To remove the rear wheel
WARNING
To avoid injury, securely support the
vehicle so there is no danger of it
falling over.
1. Fully loosen the drive chain puller
locknut and the drive chain slack
adjusting nut on both ends of the
swingarm.
1. Axle nut
2. Drive chain puller locknut
3. Drive chain slack adjusting nut
Periodic maintenance and adjustment
2. Loosen the axle nut and the brake
EAU25081
torque rod nut at the brake shoe
plate.
EAU56620
3. Lift the rear wheel off the ground
according to the procedure on
page 7-34.
4. Remove the brake pedal free play
EWA10822
adjusting nut, and then discon-
nect the brake rod at the brake
camshaft lever.
5. Disconnect the brake torque rod
from the brake shoe plate by re-
moving the nut and the bolt.
1. Brake torque rod
2. Brake torque rod bolt and nut
3. Brake rod
4. Brake pedal free play adjusting nut
5. Brake camshaft lever
6. Push the wheel forward, and then
TIP
The drive chain does not need to be
disassembled in order to remove and
install the rear wheel.
7. Remove the axle nut.
8. Pull the wheel axle out, and then
To install the rear wheel
1. Install the drive chain onto the rear
2. Install the brake rod into the brake
3. Connect the brake torque rod to
4. Install the axle nut.
5. Lower the rear wheel so that it is
7-37
remove the drive chain from the
rear sprocket.
remove the wheel.
sprocket, and then install the
wheel by inserting the wheel axle
from the right-hand side.
camshaft lever, and then install
the brake pedal free play adjusting
nut onto the brake rod.
the brake shoe plate by installing
the bolt and nut.
on the ground, and then put the
sidestand down.
7