Advertisement
3. Manual Focus
When the camera's focus mode is set to [MF], focus manually by
turning the focusing ring. (fig.❹)
Quickly rotating the focusing ring may result in delayed focus.
•
Focus mode is set using the camera. Please refer to the
camera's instructions.
•
After autofocusing in [AF+MF] mode, focus manually by
pressing the shutter button halfway and turning the focusing
ring (full-time manual focusing).
4. Image Stabilizer
This lens is equipped with an Image Stabilizer. This function
corrects camera shake, allowing users to capture sharp images.
Also, the Image Stabilizer automatically provides optimal image
stabilization depending on shooting conditions (such as shooting
still subjects and following shots). Please set the Image Stabilizer
ON or OFF using the camera settings. See your camera's
instructions for details.
•
The Image Stabilizer cannot compensate for a blurred shot
caused by a subject that moved.
•
The Image Stabilizer may not be fully effective if you shoot
from a violently shaking vehicle or other transportation.
•
The Image Stabilizer consumes more power than normal
shooting, resulting in fewer shots and a shorter movie shooting
time.
•
When shooting a still subject, it compensates for camera
shake in all directions.
•
It compensates for vertical camera shake during following
shots in a horizontal direction, and compensates for
horizontal camera shake during following shots in a vertical
direction.
•
When you use a tripod, the Image Stabilizer should be
turned off to save battery power.
•
Even with a monopod, the Image Stabilizer will be as
effective as during hand-held shooting. However, depending
on the shooting conditions, there are cases in which the
Image Stabilizer effect may be less effective.
■ Dynamic IS Function (Movie shooting only)
The EF-M18-150mm f/3.5-6.3 IS STM is equipped with dynamic
IS, effective when shooting while walking since it expands the IS
range.
• Achieves effective IS at the wide end.
• Automatically activates when the camera is set to Movie
Shooting.
0816Ni
5. Hood (sold separately)
The EW-60F hood cuts out unwanted light and protects the front
of the lens from rain, snow, and dust.
To attach the hood, align the hood's attachment position mark with
the red dot on the front of the lens, then turn the hood as shown
by the arrow until the lens' red dot is aligned with the hood's stop
position mark. (fig.❺)
The hood can be reverse-mounted on the lens for storage.
•
If the hood is not attached properly, vignetting (darkening of
the perimeter of the picture) may occur.
•
Grasp and rotate the base of the hood when attaching
and detaching it. There are cases in which it may become
deformed if the hood is rotated with it grasped near to the
rim.
6. Filters (sold separately)
You can attach filters to the filter mounting thread on the front of
the lens.
Only one filter may be attached.
CANON INC. 2016
©
Specifications
Focal Length/Aperture
18-150mm f/3.5-6.3
Lens Construction
13 groups, 17 elements
Minimum Aperture
f/22-40*
Diagonal: 74°20'-10°25'
Angle of View
Vertical: 45°30'-5°45'
Horizontal: 64°30'-8°40'
at 18 mm: 0.25 m / 0.82 ft.
Min. Focusing Distance
at 50 mm: 0.25 m / 0.82 ft.
at 150 mm: 0.45 m / 1.48 ft.
at 18 mm: 0.10x
Max. Magnification
at 50 mm: 0.27x
at 150 mm: 0.31x
at 0.25 m / 0.82 ft.:
Approx.
148 x 223 mm / 5.83 x 8.78 in.
Field of View
at 0.45 m / 1.48 ft.:
Approx. 48 x 72 mm / 1.89 x 2.83 in.
Filter Diameter
55 mm
Max. Diameter and Length 60.9 x 86.5 mm / 2.40 x 3.41 in.
Weight
Approx. 300 g / 10.6 oz.
Hood
EW-60F (sold separately)
Lens Cap
E-55
Dust Cap
Lens Dust Cap EB
Case
LP816 (sold separately)
* Applies to 1/3-stop increments. With 1/2-stop increments, it will be f/22-
38.
• Equivalent to 29-240 mm in the 35mm film format.
• The lens length is measured from the mount surface to the front
end of the lens. Add 20 mm when including the lens cap and
dust cap.
• The size and weight listed are for the lens only, except as
indicated.
• Extenders and extension tubes cannot be used with this lens.
• Aperture settings are specified on the camera. The camera
automatically compensates for variations in the aperture setting
when the camera is zoomed in or out.
• All data listed is measured according to Canon standards.
• Product specifications and appearance are subject to change
without notice.
❹
❺
ENG-2
Advertisement
