Connection; Mounting; Technical Data - Viessmann 5216 Operation Manual

4. Slow speed section
Here we have set up the section behind a signal as a slow speed section (fig. 2). This
section can also contain points. A slow speed section indicated by the colour light signal (Hp2) finally applies
applies not (only) to the stopping section directly in front of the signal, but especially to the sec-
tion behind it. Several of the circuits shown overleaf can act together on a point area, so that
trains can enter or leave the station slowly from tracks protected in this way via the point road.
Only one slow speed resistor is required!

5. Connection

1. Only connect the tracking current to the socket labelled "Eingang".
2. The output to the track now can be taken from the sockets "10 Ohm", "20 Ohm" or "30 Ohm" (fig. 3). The
higher the Ohm value, the slower the train will be. You have to determine individual the correct value.
3. You will get a resistance of 15 Ohms (red box print), if you use the "20 Ohm" socket and make an
additional connection from the "10 Ohm" socket to the "30 Ohm" socket (fig. 4).

6. Mounting

Fasten the module with the enclosed screws. During operation the resistor can get hot. Please observe
the following notes.
Caution!
Do not cover the ventilation slots!
Mount the module with the ventilation slots on the top. Do not mount it overhead (fig. 5).
Never mount or store any inflammable materials in direct nearness of the resistor.

7. Technical data

Operating voltage:
Power dissipation:
Selectable resistance value:
Weight:
Dimensions:
Do not dispose of this product through
(unsorted) domestic waste, supply it to
recycling instead.
Subject to change without prior notice. No liability
for mistakes and printing errors.
You will find the latest version of the manual on the
Viessmann website using the item number.
max. 24 V AC/DC
max. 5 W
10 Ohm
15 Ohm
20 Ohm
30 Ohm
25 g
L 5.4 x W 3.4 x H 2.2 cm
5