Bosch 0603206200 Original Instructions Manual page 21

OBJ_BUCH-420-001.book Page 21 Tuesday, February 12, 2008 8:15 AM
Technical Data
Fine-spray System
Article number
Rated power input
Spraying capacity
Atomising output
2
Required time for 5 m
paint application
Container capacity for
spray material
Length of air hose
Weight according to
EPTA-Procedure
01/2003
Protection class
Please observe the article number on the type plate of
your machine. The trade names of the individual ma-
chines may vary.
Declaration of Conformity
We declare under our sole responsibility that
the product described under "Technical Data" is
in conformity with the following standards or
standardization documents: EN 60335 accord-
ing to the provisions of the directives
2004/108/EC, 98/37/EC (until Dec. 28, 2009),
2006/42/EC (from Dec. 29, 2009 on).
Technical file at:
Robert Bosch GmbH, Dept. PT/ESC,
D-70745 Leinfelden-Echterdingen
Dr. Egbert Schneider Dr. Eckerhard Strötgen
Senior Vice President Head of Product
Engineering Certification
06.02.2008, Robert Bosch GmbH, Power Tools Division
D-70745 Leinfelden-Echterdingen
Bosch Power Tools
Assembly
PFS 105 E
3 603 B06 2..
Connecting the Air hose
W 350
(see figures A1
g/min 150
– Take the air hose 13 out of the accessory
W 105
min 6
– Remove the protective caps from both ends
ml 800
Connecting to the spray gun:
– Firmly insert an SDS connector 14 of the air
m 3.4
kg 4.9
– Turn the SDS connector until the lock can be
/ II
Connecting the base unit:
– Firmly insert the second SDS connector of
– Turn the SDS connector until the lock can be
Note: After use, reattach the protective hose
caps to the hose ends.
Before any work on the machine itself, pull
the mains plug.
A2)
–
compartment 20.
of the air hose.
hose in alignment with the arrow mark into
the hose port of the spray gun 6.
heard to latch.
the air hose in alignment with the arrow mark
into the port of the base unit 18.
heard to latch.
1 609 929 L50 | (12.2.08)
English | 21