ID Technology ClearMark Installation Operation User Manual page 24

2. Next, remove the electronic board from the bottom of the Cartridge Stall in the
printhead:
a. Remove the flat cables.
b. Remove the plate that supports the board (2 x Torx10). Pop the plate out with
a small flat head screwdriver.
3. Loosen but do not remove the two lower screws (2mm Allen wrench) holding the
bottom of the cartridge stall to the printhead face plate.
V 1.S.10 January 2021
ClearMark™
Installation, Operation & User Manual – Page 24