ID Technology ClearMark Installation Operation User Manual page 23

Removing spacers to reduce throw distance to product
By removing these two spacer plates, the print throw distance can be reduced by 2mm:
2 x
To remove the two small plates placed between the stall and the front faceplate of the
printhead, follow these steps:
1. Remove the printhead covers from both sides of the head.
To do this:
•
Remove 2 screws located on the bottom of the printhead (2mm Allen wrench)
•
Loosen (but do not remove) the screw that holds the cartridge stall to the face plate of
the print head (2mm Allen wrench)
V 1.S.10 January 2021
ClearMark™
Installation, Operation & User Manual – Page 23