Table of Contents
Advertisement
6 Service Mode
6.1.
Error Code Memory Function
1. General description
This unit is equipped with history of error code memory function, and can be memorized 16 error codes in sequence from the
latest. When the error is occurred more than 16, the oldest error is overwritten in sequence.
The error code is not memorized when the power supply is shut down forcibly.
The error code is memorized to Flash-ROM when the unit has just before powered off.
2. How to display
The error code can be displayed by ordering the following procedure:
• Preparation
Attach the fully charged Battery, and insert the memory card (32MB or more).
Remove the lens cap.
• Step 1. The Temporary Cancellation of "Initial Settings":
Set the [ Mode dial ] to "[ P ](Program AE mode)" and [ Drive mode dial ] to "Single".
While pressing [ DISP. ] button and [ AF/AE LOCK ] button simultaneously, turn the power on.
• Step 2. Execute the Error Code Display Mode:
[ Display method by pressing the buttons simultaneously ]
Press [ MENU/SET ] button, "[ LEFT ] of Cursor buttons" and [ AF/AE LOCK ] button simultaneously under the step 1 condi-
tion.
The display is changed as shown below when the above buttons are pressed simultaneously.
Normal display → Error code display → Camera information display → Normal display → .....
[ Display method from the menu display ]
Select [ ERR CODE DISP ] from the setup menu and then press [ MENU/SET ] button under the step 1 condition.
*The display is changed as shown below when [ MENU/SET ] button is pressed.
Menu display → Error code display → Camera information display → Menu display → .....
Example of Error Code Display
21
Advertisement
Table of Contents
