Table of Contents
Advertisement
3.2.3.
About Flash-ROM (IP2951) and Charging Control Microcomputer (IC1502)
When the Flash-Rom or Charging Control Microcomputer is replaced, it is need to adjust the firmware of the Charging Control
Microcomputer to the one of the Flash-ROM.
For details, refer to "10.3.2. Adjustment Specifications".
It may takes about 10 seconds. While doing the adjustment, don't turn the power off forcibly.
(It cause the Charging Control Microcomputer crush, then the camera can not turn on.)
3.2.4.
About Venus Engine (IS6001) [Located on the Main P.C.B.]:
The Venus Engine (IS6001) consists of two IC chips (DRAM and Venus), which are fixed together with solder.
(It's called, "Package On Package" type IC.)
When replacing, always replace in pairs. (Units of service parts: integrated (one pair) state.)
NOTE:
• During servicing, do not press down hard on the surface of IS6001.
• Paste the pad pasted on surface of IS6001 on surface of the IS6001 without fail after the replacement.
3.2.5.
About Flexible Cable and Connector
Do not touch carelessly so that the foreign body should not adhere to the terminal part of flexible cable and connector.
Wipe off with a clean cloth and the cotton bud, etc. when the terminal part is dirty.
8
Advertisement
Table of Contents
