Table of Contents
Advertisement
1886
If you need a different downrod length follow these steps:
1
1
10
10
WARNING
FAN FALL HAZARD
To prevent SERIOUS INJURY or DEATH:
Fan Doesn't Work
• Make sure power switch is on.
• Check the circuit breaker to ensure the power is turned on.
• Make sure the blades spin freely.
• Turn off power from the circuit breaker, then loosen the canopy
and check all the connections according to the wiring diagram.
Excessive Wobbling
• Make sure the blades are properly installed on the blade iron
posts.
• Turn the power off, support the fan carefully, and check that the
hanger ball is properly seated.
• Use the provided balancing kit and instructions to balance the fan.
11
Follow steps 1-5 to remove standard downrod pipe
2
3
8
9
2
9
8
Follow steps 6-10 to reassemble with new downrod
• VERIFY the downrod
• ALWAYS follow the
is assembled correctly
downrod assembly
by firmly pulling on the
instructions exactly.
hanger ball.
Downrod
4
3
7
4
7
• Pin must be reinserted
to secure downrod
assembly.
Troubleshooting
Noisy Operation
• Make sure the blades are properly installed.
• Check to see if any of the blades are cracked. If so, replace all of
the blades.
Remote Control of Fan is Erratic
• Make sure the battery is installed correctly.
• Install a fresh battery.
Multiple Remote Issues
• If you have multiple remotes or multiple remote-controlled fans
installed on the same circuit breaker and you are experiencing
interference or faulty operation of your remote controls, please
go to
www.HunterFan.com/FAQs and click
multiple remote-controlled fans?"
correct this issue.
5
5
6
Here is another view of
the downrod assembly
unassembled.
6
Assembled downrod
should look like this
"How do I properly install
for information on how to
Hunter Pro Tip:
Cleaning the Fan
Use soft brushes or cloths to prevent scratching.
Cleaning products may damage the finishes.
Pin
Pin
Advertisement
Table of Contents
