Troubleshooting - Philips DVDR725H Software Upgrade Instructions

Troubleshooting

Symptom
The display shows ' UP TO DATE'
The display shows ' SYS UNSUPP'
The display shows ' ERROR ' or
'ENGINE ERROR' procedure
Some of the system settings have
changed, such as the date or
language preferences.
The set does not accept the disc
8
Remedy
The system version of your DVD recorder is
already newer than that at the CD-ROM.
Y ou cannot upgrade with this disc.
Upgrading is not supported for this
configuration.
Contact your Philips Customer Care Center.
An error occurred during the upgrade. Try once
again. If problem persists, contact your Philips
Customer Care Center.
Reset the DVD Recorder as follows:
Disconnect the recorder from the mains;
Reconnect it while holding the STANDBY/ON
button pressed until the display lights up.
You will need to redo the installation procedure.
The upgrade disc may be damaged or not
properly recorded.
- If it is a CD-R you created, make a new disc,
following the guidelines closely.
- If it is a CD-ROM you received from Philips
contact your Philips Customer Care Center.