Operation - Windsor 10090240 Operating Instructions Manual

OPERATION

CONTROLS
1. Safety Lock – Prevents unintended operation of
the machine.
2. Switch Levers – Turns machine on/off.
3. Adjustment Handle – Allows the handle to be
adjusted to a comfortable operating position.
2
The handle adjust bar (86215130 - PRV
NO.14344) for the polishers are individually
preset at the factory for optimum locking
efficiency and minimum effort of engaging. It
should not be necessary to adjust the handle
adjust bar unless the relationship of the handle
adjust bar nut (86136360 - PRV NO. 57275) or
fixed clamp bolt (86136700 – PRV NO. 70692)
and their corresponding nuts (86136360 –
PRV NO. 57275) and washer (86010720 –
PRV NO. 87086) have been disturbed. The
handle can be positioned to be locked with the
handle adjust bar pointing either up or down.
In order to change the position the handle and
bolt must be removed and rotated 180
degrees. It is incorrect to make it lock opposite
from the way it was assembled by applying
more force to the nut. From the factory the
locking is in the up position when the machine
handle is locked. The pivot pin (86222560 –
PRV NO. 66334) on the handle adjust bar is
off center, in relationship of the screw to the
axis of the (see drawing). To adjust handle
adjust bar, tighten nut on handle while in the
locked position. The handle is locked when the
screw is to the outside of the machine and the
flat on the opposite side of the handle is flush
to the bracket.
2-3
1
2
LOCK
UNLOCK
3
STORM POLISHER 86221940 12/29/06
1. To adjust handle lock, tighten nut on handle while
in the locked position. Optimum locking force and
ease of locking is accomplished when the locking
lever nut is set to a torque of 30 to 50 inch pounds
in the locked position.
2. Gap between clamp halves at the front should be
to the gap in rear when the handle adjust bar is
adjusted properly and in the locked position (gap
approximately 1/16").
8 6 2 2 5 7 1 0
P R V N O . 8 7 2 0 2
8 6 2 1 5 1 3 0
P R V N O . 1 4 3 4 4
8 6 2 2 3 5 5 0
P R V N O . 6 7 4 3 0
8 6 1 3 6 7 0 0
P R V N O . 7 0 6 9 2
2
S H O W N H A N D L E IS
IN L O C K P O S IT IO N
86222560
PRV NO. 66334
PIVOT PIN C L
HANDLE C L
8 6 1 3 6 3 6 0 (2 )
P R V N O . 5 7 2 7 5
1
8 6 0 1 0 7 2 0
P R V N O . 8 7 0 8 6
LOCKING SIDE FLAT