Drain Piping - Daikin CTXS07WVJU9 Installation Manual

Indoor Unit Installation
5.

Drain piping

1) Connect the drain hose, as described on the right.
• Avoid placing the end of the drain hose in a drainage location that
could cause bad odors or corrosive gas to flow backward into the
outlet.
• The drainage water may change color due to bacteria or other
organisms. Place in a location where the flow of drainage water will
not cause a problem.
• Minimize the number of bends in the drain hose as much as possible.
If bending the drain hose, bend it gently.
2) Remove the air filters and transfer some water to the indoor heat exchanger by pouring water
into the drain pan.
3) Make sure that water flows out of the drain hose.
4) If drain hose extension or embedded drain piping is required, use appropriate parts that match
the hose front end.
Figure of hose front end
• When drain hose requires extension, obtain an extension hose
with an inner diameter of 5/8 inch (16mm).
Be sure to thermally insulate the indoor section of the
extension hose.
• When connecting a rigid polyvinyl chloride pipe
(nominal diameter 1/2 inch (13mm)) directly to
the drain hose attached to the indoor unit as
with embedded piping work, use any
commercially available drain socket (nominal
diameter 1/2 inch (13mm)) as a joint.
9
Getting higher
Wrong
Drain hose supplied
with the indoor unit
Drain hose supplied with Commercially available
the indoor unit drain socket
(nominal diameter 1/2 inch
(13mm))
Make a downward slope
Leave a gap of 1-15/16 inches (50mm) or
more at the end of the outlet
With the end of the hose
Containing waves
in the drain outlet
Wrong
Indoor unit Extension drain hose
drain hose
Heat insulation tube (field supply)
Commercially available
rigid polyvinyl chloride pipe
(nominal diameter 1/2 inch
(13mm))
Wrong
■
English