LG CordZero A9 K Owner's Manual page 22

22 OPERATION
• Press down at the center
in place.
Attaching the Mop Pads
Use the standard mop pads for general cleaning.
For stubborn stains, use the heavy duty mop pads.
WARNING
• To avoid injury, do not attach the mop pads
while the mop plates are moving.
• Do not insert your hand between the rotating
mop plates. Doing so may result in injury.
1
Wet both sides of the mop pads with water
and squeeze out any excess water before
attaching the pads.
• Do not attach pads while they are dripping
wet.
• Attaching and using mop pads while they
are dry may affect the cleaning
performance.
2
Place the mop nozzle upside down on the
floor.
3
Align and attach the center of the mop pad
with the center of the mop plates.
• Attach the mop pad so the striped side is
visible. Attaching the mop pad upside down
or improperly may affect the cleaning
performance.
4
Attach the mop nozzle to the appliance.
to lock the tank
g
Adjusting the Amount of Water
Press the Water Adjustment button at the rear of
the mop nozzle to adjust the amount of water
released onto the mop pad.
• High Mode: Press the High Mode button
the way down to clean ingrained dirt or supply a
large amount of water.
• Low Mode: Press the Low Mode button
the way down to supply a small amount of water
for cleaning wood or other flooring that can be
damaged by too much water.
• STOP: Press the Low Mode or High Mode
button halfway to toggle back to the STOP
position. This stops the supply of water so you
can go over areas that are already wet.
• By default, the water adjustment button is set to
STOP.
Using the Mop Nozzle
1
Attach the water tank and mop pads to the
mop nozzle.
2
Press the Water Adjustment button to adjust
the amount of water.
3
Press the Power
Drying the Water Tank and Mop
Pads
Drying the Water Tank
When cleaning is completed, make sure to empty
the water tank and dry it before storing the mop
nozzle.
CAUTION
• Turn the water inlet caps to make sure they
remain open when storing the water tank. If the
caps are closed and the tank is not completely
dry, the trapped moisture can cause odors.
• Do not remove the water inlet caps from the
water tank. Caps may tear.
• Do not add detergent, vinegar or baking soda to
the water tank when washing. It is not easily
removed from the water tank, and may soil
floors.
b
t button to start cleaning.
all
a
all