4.2 Measuring range selection..........................8 4.3 Selecting response time..........................8 4.4 Wiring................................9 4.5 Zeroing................................9 5 Disposal....................... 10 6 Warranty policy....................11 Copyright HK Instruments 2023 www.hkinstruments.fi User guide Version 1.0 2023 Information is subject to change without prior notice. EN - 104.004.008ug...
Published: 31.05.2023 3 (11) 1 Introduction Thank you for choosing an HK Instruments DPT series differential pressure transmitter. The DPT series is intended for use in commercial environments. The DPT-2W series differential pressure transmitter provides a 4...20 mA loop output.
±0.04 mA at 25 °C, load 100 Ω Accuracy Display (-D models) 3 1/2 digit display Operating conditions Copyright HK Instruments 2023 www.hkinstruments.fi User guide Version 1.0 2023 Information is subject to change without prior notice. EN - 104.004.008ug...
Read this user guide carefully before commissioning, using or servicing this device. To avoid any kind of damage to people or property, follow the instructions carefully. HK Instruments is not liable for any hazards or damages to people or property which are caused by ignoring the using or installation instructions.
Important: Don't use excessive force when tightening the mounting screws. Install the measuring hoses carefully so that the hoses don't bend too tightly. Too tight curves may prevent the air flow to the sensor. Copyright HK Instruments 2023 www.hkinstruments.fi User guide Version 1.0 2023 Information is subject to change without prior notice.
The indicator light and display (-D models) indicate the selected response time. Indicator light Display Response time Three short flashes 0.8 seconds Two long flashes 4 seconds Close the cover. Copyright HK Instruments 2023 www.hkinstruments.fi User guide Version 1.0 2023 Information is subject to change without prior notice. EN - 104.004.008ug...
Release the zeroing button. Zeroing starts and the indicator turns off. The zeroing is complete when the indicator light flashes two times. Connect the pressure measurement hoses. Copyright HK Instruments 2023 www.hkinstruments.fi User guide Version 1.0 2023 Information is subject to change without prior notice.
Printed circuit boards need selective treatment according to IEC 62635 guidelines. To aid recycling, plastic parts are marked with an appropriate identification code. Contact your local HK Instruments distributor for further information on environmental aspects and recycling instructions for professional recyclers.
The warranty includes the repair of a defective part or device, or if needed, a new part or device, but not installation or exchange costs. Under no circumstance is the seller liable for damages compensation for indirect damage. Copyright HK Instruments 2023 www.hkinstruments.fi User guide Version 1.0 2023 Information is subject to change without prior notice.
Need help?
Do you have a question about the DPT-2W and is the answer not in the manual?
Questions and answers