Table of Contents
Advertisement
6.1.6 Press white color "OFF" key to shut down, the instrument will automatically shut down after
about 5 minutes without any operation to reduce battery consumption.
b.
Danger! High voltage! Please pay attention to safety!
6.2.1 Use any clamps to clamp on the tested wire. If the conductor has electricity (within the
setting range of live line voltage, AC70 ~ 1000V), the lamp of L1/U, L2/V or L3/W will light
up.
6.2.2 Clamps and lamps corresponding sheet:
Clamp Mark
L1/U (Red)
L2/V (White)
L3/W (Blue)
c.
Danger! High voltage! Please pay attention to safety!
6.3.1 Use any clamp to clamp on the three-phase line separately. If it is default phase, the lamp
L1, L2 or L3 will not light up.
Live wire inspection, simple electricity detection.
Default phase judgment, open circuit searching, breakpoints location.
Lamp light up symbol
L1/U lamp light up
L2/V lamp light up
L3/W lamp light up
7
Advertisement
Table of Contents
