Advertisement
6.3 CLEAN THE MOTORIZED BRUSH
1
2
1. Turn off the power and release the motorized brush.
2. Turn the button on the bottom of nozzle by coin to "
3. Open the roller fixing cover.
4. Lift up one side of the roller and take it out.
5. Along the groove on the roller, remove twirled hair or blockage.
6. Place back the cleaned roller.
7. Cover the fixing cover and turn the button back to "
6.4 UNBLOCK
①This product has a protection function.
When the roller brush is stuck by the
winding, it will automatically cut off the
power to the motorized brush. Please turn
off the product and unblock roller
immediately. (Please refer to 6.3）
②When the machine duct is blocked,
the protection device will cut off all
power, check and clean the motorized
brush, connection tube or host air duct,
remove the blockage and let it cool
down before usage again.
3
4
" position.
"position .
7. PROBLEM SOLVING
There are some simple problems in the process of use that can be resolved by
reference to the following methods.
Problem
Possible causes
Product will not
●Running out of power
start
No suction or weak
●Dustbin is full of dust
suction
●Filtering is not correctly assembled or
dust blocked the HEPA
●Nozzle and/or tubes blocked
Nozzle roller does
●Roller blocked, protection function
not rotate
works
Using time shorter
●Battery not fully charged
WARNING: FOR SOLVING OTHER PROBLEMS OR REPLACEMENT,
PLEASE ALWAYS RESORT TO PROFESSIONALS SPECIFIED, ANY
UNAUTHORISED REPAIRING ARE NOT COVERED BY WARRANTY.
R Weatherdon & Co Pty Ltd
www.weatherdon.com.au
Solving
●Referring to "battery
charging" instruction,
charge the battery
●Empty the dust
●Assemble the filter again
or clean/replace filter
●Refer to "unblock"
instruction, unblock the
nozzle and/or tube
●Refer to "unblock"
instruction, unblock the
nozzle
●Refer to "Battery
charging" instruction,
charge the battery
Imported By:
Made in China
Advertisement
